There is a lot of information out there on pedalboard power supply Australia options and all things to do with guitar pedals. All of that information can cause some confusion though, and can also create more hesitancy when you are trying to make good purchasing decisions. Here is some concise information that should help you gain an understanding.
The right power supply is essential
When it comes to electrical instruments, and guitar overdrive pedals, the right supply of power is essential to reduce capacitance. As well as causing noise you do not want in your signal, a bad supply of power can actually cause damage too, to the pedal, and in some cases, that damage to the components might even fry it. Here are a few tips to help guide you towards the right options.
Tips on pedalboard power supply Australia
- Voltage is the unit of measurement that directs what AC adaptor or what battery is needed.
- GPO or general power outlet is measured in AC, different countries have different voltages from the outlets. Brunei has 240V, the US 120V, Australia and New Zealand have up to 240V.
- On the pedal, the socket is DC power, usually though some pedals might have AC requirements.
- How much power the stompbox needs is the current. Voltage is a type of power, current is how much is needed.
- Guitar pedals like overdrive pedals have a standard measurement of mA or milliamps.
- Pedal power sockets are 9V DC negative tip polarity but a few pedal types need DC positive tip polarity power plugs. Make sure you know which types you have so you do not damage the pedal with the wrong plug.
- The voltage pedals require ranges from 12V, 18V and more. Most come with their own adaptors, but if you want to use them with other pedals you need a board and plug fittings to push up the power. Some larger series of power supplies have parallel outlets with different voltages to meet those needs.
- Low-cost standard power adaptors are referred to as Wall warts.
- Low current draws of under 20mA include simple overdrive pedals, analog overdrives, fuzzes and distortions.
- Digital pedals on the other hand need 50 to 100 mA unless they are heavy on features in which case it can require a lot more.
- Bad power supply using cheap adapters or bad wiring is called dirty power and it does negatively impact your tone.
- Having a good power supply that meets your needs is very important to look after your equipment and get the best sound.
When it comes to a power supply, you want to invest a bit more money so you do not end up damaging equipment or experiencing a dull tone from capacitance. Take some time to save, then get your hands on a high quality power supply.