Tree Removal Adelaide can be quite dangerous and sometimes even life threatening. It’s not recommended to eradicate a stump on your own until and unless its small one which you’re confident you could handle safely. Otherwise, this process needs to be left in hand of professional trained and well equipped service contractors.
In case you have a stump on the property which is small, but also has to be eradicated you may possibly do it on your own with the right knowledge, tools as well as planning.
Preparation for tree removal
Right preparation for removal of mall trees includes gathering all that is needed supplies, and a comprehensive inspection of trees like Arborist Adelaide. You may look to check if tree leans in a way or plan an escape route if it doesn’t fall in the way you wanted it to.
Also, you may examine if there’re any kind of obstacles in the direction of the trees including the structures, vehicles as well as other trees. In case you’re sure that there sufficient safe clearance for trees to fall down, you may move on to gather your tolls and equipment. This includes:
- Safety gear i.e. utility gloves, hard hat, goggles, steel toe boot, etc.
- Hacksaw or Axe
- First aid kit
For removing a tree
Once you’ve collected all the required supplies and equipment for removing tree in Adelaide, you may get started with the process of removing tree. First of all, use the axe for knocking on bark a couple of times, and in some places for learning how hollow or solid the tree is. Finding lesser dense area for cutting would be easier.
Next, try planning which side of tree you would like to make the cut. Look to check if the tree leans naturally, it’s better to just cut down a tree in direction where it wants to fall naturally. Just make sure that the area where it drops is levelled so that the tree doesn’t bounce or roll once it falls.
Try and make a horizontal cut at the hip height and approximately 1/3rd in the tree. Do it on the side of tree where you would like it to fall. In case you wish the tree to go down right, you should make the cuts on same side so that it falls inside, i.e. towards the cuts.
The 3rd cut for tree removal of the stump is known as back cut and it needs to be made on opposite side of the wedge cut. This would help in making the tree fall on side of the wedge cut. Just make it approximately 1.5 inches above wedge cut and thick. You may even use wedge for preventing it from settling on the chain saw.
For Tree Removal Adelaide you should have the right tools and equipment. With the help of these tools and equipment you would be able to bring the tree down in the right manner. Thus, for removing the tree you should first hire/buy them.
Source: Steps to tree removal Adelaide